Product Details
Supplies 4 outputs (8 for the 4 A and 6 A models) of nominal, continuous power for a host of electronics and access devices, including:
- Electromagnetic locks
- Electric strikes
- Specialty locks
- Access control systems
- Motorized latch retraction (MLR)
- Egress doors and exit devices
Technical Details
DKPS-2A
- Input voltage: 110 to 220 VAC, 50 to 60 Hz, 2.4 A
- Output voltage: selectable 12 or 24 VDC; 4 voltage outputs, each output max 2.0 A, with electronic over-current protection set at 2 A
DKPS-4A
- Input voltage: 110 to 220 VAC, 50 to 60 Hz
- Output voltage: selectable 12 or 24 VDC; 8 voltage outputs, each output max 2.0 A, with electronic over-current protection set at 4 A
DKPS-6A
- Input voltage: 110 to 220 VAC, 50 to 60 Hz, 2.5 A
- Output voltage: selectable 12 or 24 VDC; 8 voltage outputs, each output max 2.0 A, with electronic over-current protection set at 6 A
Shared features
- Built-in dedicated charger for sealed lead acid or gel cell type batteries
- Battery load and charge test every 48 hours
- Battery reversal protection
- Low battery indication at 11.40/22.80 volts
- Low battery disconnect at 10.10/20.30 volts
- Immediate switch-over to standby battery upon AC failure
- Common "Batt. Fault" CMOS relay and indicator for all battery and charger faults, 30 VDC at 60 mA
- CMOS relay output and indicator for AC failure within 60 seconds, 30 VDC at 60 mA
- LED status display on enclosure door
- Common "Out Fault" CMOS relay for DC failure on any of the outputs, 30 VDC at 60 mA
- Battery charging leads included
- Fire Panel Disconnect Board (FPDB) standard
- Tamper switch optional (required when the installation must meet UL 294 Edition 6 or higher)
Components
Three models available:
- DKPS-2A: 2 A
- DKPS-4A: 4 A
- DKPS-6A: 6 A
Applications
- Power to access control systems
- Power to electric locking systems
- Power to electromagnetic locking systems
- Power to a host of other electronic and access systems
Product Downloads
- pdf
- pdf
- pdf
