Defender 720 - Bolt Work

  • Defender 720

    1/1Defender 720

  • Defender 720

Tuotteen yhteenveto

1- to 3-sided bolt work for safes CEN II-V.

The bolt work is protected by manganese steel plates. Tightening cords are used as additional protection. Due to two patented front shaft supports in form of integrated massive steel elements a very high manipulation protection is achieved. During the opening process the blocking is released by the forward motion of the shafts II and III. Afterwards the shaft I is drawn back.

No defined locking order in case of 2-lock operation.

tuotteen yksityiskohdat

Bolt work

  • Dimensions base plate 325 x 415 mm
  • Installation applications
    • 2-lock operation
    • 3-sided (front shaft I, upper shaft II, lower shaft III)
    • Shaft I throw 30 mm, shaft II/III throw 39 mm, opening angle of handle 125°
    • Shaft connections: Ø 10.5 mm
    • Mounting position of locks: horizontal, bolt left, bolt throw 8.7 - 12 mm, blocking of vertical shafts
    • Lock mounting: 4 M6 threaded bushes
    • For right hand doors, opening clockwise
  • Manipulation protection
    • High resistant shaft I, release by forward motion of the shafts II/III
    • Base plate with riveted manganese steel plate, 2 mm thick
    • Side manganese steel stripes
    • Manganese steel angles as drilling protection
    • Integrated relocker with tightening cord, polyester, 3 m length, detent in blocking position
    • Indirect blocking points
  • Electrolytic galvanised steel, cutting edge blank
  • Gear drive with follower 11 mm
  • Prepared for Ristow-Element 4.4
  • Prepared for position indicator of shafts
  • Weight approx. 9,300 g

Näytämme mielellämme lisää